• Online only

LED power supply | Mean Well LPC-20-700

zł59.34
Shipment in 1-2 business days
LED Power Supply
zas_MW_LPC-20-700
Led power supply key features: 700mA output, 20W power, IP67 rating, sealed design. Read the full specs below and choose the best fit. Add to cart with confidence.

Look also at our: LED strips | Other LED Power Supplies | LED Drivers & Controllers

Quantity
  Delivery

1-3 dni (PL), 3-10 dni (non-PL)

 

Privacy Policy

  Return Policy

14 days

LED power supply - choose the right one for Your project.

LED power supply parameters 700mA DC and 20W headroom for demanding loads. The sealed body protects electronics from dust and moisture. With IP67 sealing, it resists dust and temporary immersion. This model comes from the trusted Mean line. Typical uses include outdoor signage, garden and facade lighting, and damp or dusty areas. It brings stable output, low ripple, and premium build quality.

Protections built into the led power supply

  • Over-voltage protection (OVP) shields LEDs from spikes.
  • Over-current protection (OCP) prevents overload damage.
  • Short-circuit protection (SCP) auto-recovers after faults.
  • Over-temperature protection (OTP) limits heat-related failures.
  • EMI filtering and, where applicable, active PFC for cleaner power.

When to use power injection

Projects using LED tape at 12 V or 24 V can suffer voltage drop on long runs. Brightness fades and colors shift. Feed 12 V or 24 V at multiple points to keep light uniform. For constant-current modules like this unit, power injection is not used; instead, wire series chains within the rated voltage window. Combine this method with a 700ma 20w power supply to stabilize each section.

Sizing your power source

Sum the LED load and add a 20–30% margin. This protects lifespan and thermal performance. Match polarity, check ambient temperature, and allow airflow. For sealed installs, derate output. Use the mean well lpc-20-700 psu only where it adds value, and pick certified units for safety.

FAQ

Q: Can I run several strips in parallel?
A: Yes, if total current stays within the limit and each branch is fused.

Q: Why does my strip dim at the end?
A: Voltage drop. Add power injection and use thicker supply cables.

Choose cables with low resistance, avoid sharp bends, and double-check polarity before power-up. Test sections incrementally to catch wiring errors early.

Ready to build? Order today for premium performance and dependable light.

Look also at our: LED strips | Other LED Power Supplies | LED Drivers & Controllers

zas_MW_LPC-20-700

Data sheet

Power supply type
Constant Current 350mA, 700mA,... (CC)
Rated power
21W
Output Current of power supply (CC)
700mA
Output voltage range (CC)
9V - 30V
Rated power
21 - 30W
No. of outputs
1
Grounding
No
Way/protocol of dimming
N/A
Dimensions (L x W x H) [mm]
118/35/26
IP grade
IP67
Mounting way
Double side adhesive tape (not included)
Mounting way
Screwed (screws not included)
Mounting way
Loose (no tension on the cables)
Input voltage
AC 230V
Case type of power supply
Isolated / secured
Case type of power supply
Waterproof
Case material
Plastic
Interface
Integrated input and output cable
Warranty
2 years

Related products

(There are 16 other products in the same category)